Time at JLM Shop:
We are back to work and starting to clear back orders now

Hybrid Opamp Built

Hybrid Opamp Built
  • Click to enlarge

$64.90AUD inc GST for Australian Customers
(Approx $44.08USD outside Australia)


Product Information
Stock Level2

The JLM Hybrid is a fet input IC opamp with high current output drive transistors. It can have the output transistors set to run in Class A/B or Class A Mode. It also has on board DC Servo that can be enabled by soldering two solder pads together under the PCB. It is pin compatible with the JLM99v , 990, 992 , 993 , MM99, 2520. Sound wise in class A/B the opamp is fast and transients snap at you. In class A the top end softens down and sounds silky a bit like the 99v but with super tight low end.

Can be used in precision Mic pres, EQ gyrators, virtual earth summing stages, headphone amps, balanced in receivers and output drivers.

JLM Hybrid opamp circuit PDF

Specifications

  • 1.1" x 1.1" PCB
  • THD = 0.008%
  • Min Load = 50ohm
  • Maximum power rails = +/-24vdc
  • Idle Current in class A/B = 10to 12mA
  • Idle Current in class A = 25mA to 30mA

Solder Links on back of Hybrid PCB to Set Class A or AB and DC Servo.


Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

Please enter a valid email address.
This field is required.
Top

 

© 2001-2021. All rights reserved.