Powerstation 5 Rail Power Supply Kit v5 Easy Mount

(Approx $44.34USD for customers outside Australia)
Click USD currency to see option prices in approx USD or choose your preferred currency option.


INC 10% GST for Australian Customers

(Quantity discounts available)

Stock Level: 79

Product Information

PowerStation Ver. 5 Easy Mount kit is a Linear based universal power supply which can generate 5 voltage rails from a single or dual 15 to 30vac power transformer.
Powerstation Ver 5 Easy Mount has rearranged PCB layout to even improve on its already outstanding performance and can mount to side and bottom of cases with no bracket 
It has one pump charge rail for 48vdc, 2 +/- Rails that can be set from +/-2v to 37v by a 25turn trim pot.
If ordering Powerstation kit built and testedplease add the voltages you need each rail set to 48v? +V1? +V2? -V1? -V2? and what power transformer you are using? to the comments box at the end of the checkout procedure.
All regulators are on one side for easy heatsink or case mounting. 
With optional 10 Amp bridgerectifier fitted which replaces D1 to D4 on lastest Ver 3 PCB. The old 1amp total for +/-V rails can now be boosted to a full 3amp total for +/-V rails (1.5amp per regulated output) .
Otherwise normal Powerstation kit can supply 1amp total shared between  both +/-V rail and 300mA +48vdc.
Also has back overlay showing the terminal labels.
The PowerStation Ver. 5 PCB is 4.11" wide (104.4mm) x 2.15" deep (54.5mm) x 1.1" (28mm) high from top of tallest cap to lowest solder joint under the PCB.
PowerStation kit Build Thread here

PowerStation transformer and heatsink calculator here


Quantity Discounts

You can save money on this item when you purchase several at a time. The table below shows the minimum quantities required to benefit from this offer, and how much they'll cost.

QuantityPrice per unit

Customer Reviews

This product hasn't been reviewed yet. Write a review


© 2001-2018. All rights reserved.