Time at JLM Shop:

Fet DI Kit

Fet DI Kit
  • Click to enlarge

$44.00AUD inc GST for Australian Customers
(Approx $28.25USD outside Australia)

(Quantity discounts available)


Product Information
Quantity Discounts
Stock Level17

 JLM FET DI Kit just plugs into the GO Between or GO between PLUS or Any Baby Animal type PCB by a 10pin IDC cable which will do all connections and power the DI or you can just cut into the Cable coming from the Mic Input XLR that goes to the input transformer primary on any mic pre and it only needs one +12v to + 48v power rail to run on. It uses the two FETs running as a unity gain impedance converter so it can drive 200ohm loads. It has a 1Meg input impedance on the jack so the loading to the guitar pickup is the same as a Fender or Marshall Amp. Inserting the jack switches the small relay on the DI from the mic input and sends the active DI into the input transformer. New Fet DI uses a Cliff S4 socket which can bolt easy to any 1 to 5mm front panel. The Active DI Kit can be battery or Phantom powered when used externally but needs a output transformer if phantom powered.

PCB is 2.45" (62.25mm) x 1.3" (33.15mm). DI socket is 10mm in from left edge. Requires one 11.5mm hole for DI socket and has 16mm plastic disc on front panel around a chrome nut.

You can save money on this item when you purchase several at a time. The table below shows the minimum quantities required to benefit from this offer, and how much they'll cost.


QuantityPrice per unit
1$44.00AUD
8+$38.00AUD
16+$36.00AUD
24+$34.00AUD
48+$32.00AUD

Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

Please enter a valid email address.
This field is required.
Top

Follow Us

Mailing List

Enter your e-mail address to receive our newsletter
Please enter a valid email address.
Email address already subscribed. Continue if you wish to unsubscribe.
Subscribe
Unsubscribe