Time at JLM Shop:
Thanks everyone for your orders and hoping you and your families are safe and well. AusPost Express EMS shipping has improved and standard Pack and Track is also available again to some countries but taking longer than Express. We have also included a TNT Courier shipping option which should be faster for urgent orders. Thank you for your patience and understanding in these trying times. Stay Safe.

Hybrid Opamp PCB

Hybrid Opamp PCB
  • Click to enlarge
  • Click to enlarge

$7.70AUD inc GST for Australian Customers
(Approx $5.31USD outside Australia)


Product Information
Stock Level59

PCB for building the JLM Hybrid opamp with high current output drive transistors. It can have the output transistors set to run in Class A/B or Class A Mode. It also has on board DC Servo that can be enabled by soldering two solder pads together under the PCB. It is pin compatible with the JLM99v , 990, 992 , 993 , MM99, 2520. Sound wise in class A/B the opamp is fast and transients snap at you. In class A the top end softens down and sounds silky a bit like the 99v but with super tight low end.

Can be used in precision Mic pres, EQ gyrators, virtual earth summing stages, headphone amps, balanced in receivers and output drivers.

JLM Hybrid opamp circuit PDF

Specifications

  • 1.1" x 1.1" PCB
  • THD = 0.008%
  • Min Load = 50ohm
  • Maximum power rails = +/-24vdc
  • Idle Current in class A/B = 10to 12mA
  • Idle Current in class A = 25mA to 30mA

Solder Links on back of Hybrid PCB to Set Class A or AB and DC Servo.


Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

Please enter a valid email address.
This field is required.
Top

Follow Us

Mailing List

Enter your e-mail address to receive our newsletter
Please enter a valid email address.
Email address already subscribed. Continue if you wish to unsubscribe.
Subscribe
Unsubscribe