Time at JLM Shop:

PM Opamp Adaptor Kit v2

PM Opamp Adaptor Kit v2
  • Click to enlarge

5.0 average, based on 1 reviews

$27.50AUD inc GST for Australian Customers
(Approx $17.57USD outside Australia)

(Quantity discounts available)


Product Information
Quantity Discounts
Stock Level34

PM Adaptor kit v2 can replace old TA7322P & HA1457 SIL opamps used in many old Yamaha PM2000, M1516, M1524, M1532 etc consoles.  

Uses dual NE5532AP as one opamp so can drive 300ohm loads and run on +/-25vdc max. Improves performance especially in summing amp positons.

In some postions in the console that are tight is it best not use to use the DIP8 socket but instead solder NE5532AP direct to PCB.

Parts list

  • Adaptor PCB
  • 2 x 4v7 Zener diode
  • DIP8 machined socket
  • NE5532AP Dual Opamp
  • 9 gold pin strip
  • 9 gold pin plug
  • 2 x 10R resistors
  • 1uF 50v mono cap

 

You can save money on this item when you purchase several at a time. The table below shows the minimum quantities required to benefit from this offer, and how much they'll cost.


QuantityPrice per unit
1$27.50AUD
8+$24.00AUD
16+$23.00AUD
24+$22.00AUD

Customer Reviews

Average Rating: 5

esteban.marquez:cuan

12345
esteban.marquez:cuando tenemos el tpmeio para hacerlo lo antes posible, lo hacemos.Esperamos que te ayude a llevar a cabo tu proyecto. No olvides verificar el diagrama contra el circuito impreso antes de trabajar el circuito impreso en la placa virgen.Saludos cordiales (Sat Sep 26 2015, 15:11 pm )

Write Review

Please enter a valid email address.
This field is required.
Top

Follow Us

Mailing List

Enter your e-mail address to receive our newsletter
Please enter a valid email address.
Email address already subscribed. Continue if you wish to unsubscribe.
Subscribe
Unsubscribe