Time at JLM Shop:
Thanks everyone for your orders and hoping you and your families are safe and well. We are away until the 2nd Oct. You can still order from the web shop and orders will be shipped when we return. Stay Safe.

Hybrid SMD Opamp Built

Hybrid SMD Opamp Built
  • Click to enlarge

$64.90AUD inc GST for Australian Customers
(Approx $44.27USD outside Australia)

Product Information
Stock Level8

The JLM Hybrid is a fet input IC opamp with high current output drive transistors. It can have the output transistors set to run in Class A/B or Class A Mode. It also has on board DC offset trimpot that can be enabled by soldering two solder pads together under the PCB. It is pin compatible with the JLM99v , 990, 992 , 993 , MM99, 2520. Sound wise in class A/B the opamp is fast and transients snap at you. In class A the top end softens down and sounds silky a bit like the 99v but with super tight low end.

Can be used in precision Mic pres, EQ gyrators, virtual earth summing stages, headphone amps, balanced in receivers and output drivers.




  • 1.1" x 1.1" PCB
  • THD = 0.008%
  • Min Load = 50ohm
  • Maximum power rails = +/-24vdc
  • Idle Current in class A/B = 10to 12mA
  • Idle Current in class A = 25mA to 30mA

Solder Links on top of Hybrid PCB to Set Class A or AB


Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

Please enter a valid email address.
This field is required.

Follow Us

Mailing List

Enter your e-mail address to receive our newsletter
Please enter a valid email address.
Email address already subscribed. Continue if you wish to unsubscribe.