MONO Ver2 Mic pre kit BUILD THREAD

[kellyad33]

I just ordered the mono v3 kit.

I was considering trying a Lundahl LL1538 as I have one from a different project. Will this fit without modification? Is it a straight drop in?
(I haven't really looked at the schematic or anything yet but just thought I'd check anyway)
Cheers

Yes you will see the pcb has the LL1538 pinout and outline on it

Fantastic, appreciate the response

[kellyad33]

Just finishing up this build but a quick question.

I went with the dual JLM99v opamps for the Mono v3. Do I solder the opamps directly to the board? Or was it supposed to come with the pin risers that you normally have in your preamp builds for the opamps?

Not sure if it's a height issue though with the risers but thought I should check.

[Joe Malone]

Just finishing up this build but a quick question.

I went with the dual JLM99v opamps for the Mono v3. Do I solder the opamps directly to the board? Or was it supposed to come with the pin risers that you normally have in your preamp builds for the opamps?

Not sure if it's a height issue though with the risers but thought I should check.

HI
Yes should off been 12 1mm sockets added in. I will ship them down today (monday) so you should have them tomorrow

[kellyad33]

Just finishing up this build but a quick question.

I went with the dual JLM99v opamps for the Mono v3. Do I solder the opamps directly to the board? Or was it supposed to come with the pin risers that you normally have in your preamp builds for the opamps?

Not sure if it's a height issue though with the risers but thought I should check.

HI
Yes should off been 12 1mm sockets added in. I will ship them down today (monday) so you should have them tomorrow

Legend, thanks Joe