As mentioned I'm rewiring an old retro 6 slot Rebus lunchbox which is all point to point ie; no pcb rails etc. The exisiting wiring was such a mess, I just want to check I have the edge connector loom correct;
Can you please confirm for the TG 500's (and my API 512c's);
EDAC Pin 2; Output/XLR Pin 2
EDAC Pin 4; Output/XLR Pin 3
EDAC Pin 5; Output/XLR Pin 1 Shield
EDAC Pin 8; Input/XLR Pin 2
EDAC Pin 10; Input/XLR Pin 3
EDAC Pin 12; +16vdc
EDAC Pin 13; psu ground
EDAC Pin 14; -16vdc
EDAC Pin 15; +48v
Two quick questions;
a) Input/XLR Pin 1 (shield) goes where?
b) Is this all good for +48v?
Many thanks as always, Nathan @ Mixosmosis
