Log In or
CLICK YOUR CURRENCY
Time at JLM Audio:
Enter your e-mail address to receive our newsletter
Your basket is empty.
Dual99v500 Mic Pre
Festoon bulb which fits into the JLM Large VU meter light box.
Out of stock.
Matched Opto Pair for LA500 and LA500A.
24v (+/-12v) to 5v 1W SMPS as used in our VUPPM kit
5v to +/-12v 1W SMPS as used in our VUPPM kit
DB25 shielded cover
DB25 Female connector with solder cup rear connections
DB25 Male connector with solder cup rear connections
LED festoon bulb which fits into the JLM Large VU meter light box. So you will never have to change the bulb again. Led uses less than 5mA compared to the 95mA the origin bulb used.
This warm white Led lamp is very bright so a series resistor like 1k to 3k3 is recommended…
Double Ferrite Bead used in BAN kits
You need 2 Double Ferrite Beads for each BAN PCB
Pair of 10 pin IDC Cable Headers
2SK170 FET as used in our FET DI kit.
500mm length of 10 wire grey ribbon cable for use with IDC plugs
2 x 9v NiMH rechargeable batteries for MONO mic pre kit
25Amp 400v Bridge rectifier for use with our AMP kit or most power amplifier or high current power supplies.
Set of 8 soft limiter 3.5mm stereo plugs set to match your A/D converter. The TMP8 ships with a set new so you only need to order another set if you change to a A/D that has a different clip level. Just mention your A/D type or the dBM or dBu clip level in the comments box on checkout so we can supp…
DI Socket for OPA Opamp DI kit
Will replace all sockets that look the same like in Lexicon LXP1 etc.
Cut off any pins on new socket that are not on original old socket and fit to PCB.
470uF 50v Capacitor used in our Baby Animal, Baby Animal Dual and Baby Animal Neutral kit and PCB's. 10mm diameter.
1000uF 50v Capacitor used in our AC/DC and Powerstation kit. 13mm diameter.
© 2001-2016. All rights reserved.
I accept cookies from this site.
eCommerce by CubeCart