dane999 wrote:Hi Joe,
I'm planning on building a balancing unit for a Studer 169 with 14 regurgitators, and currently designing the front panel.
Could you please precise the spacing between XLRs, I'm not sure where tu put the 1'' spacing you specified. If you have somewhere the spacing between the 22mm XLR holes centers, it would be perfect !
I understood the PCBs can come by sets of 8, respecting this spacing, can you confirm it is doable to add 6 more next to the first 8, without modifying the spacing between the PCB mounted XLRs ? Or maybe I can order a row of 14 linked ?
Thank you !
HI the spacing between XLR centres is 1" or 25.4mm. The PCBs are 1" or 25.4mm wide with the XLR in the centre of the PCB ends. So the spacing between the 22mm XLR holes is 3.4mm.
You can end stack more 8 way regurgitator PCBs with the same 1" or 25.4mm spacing as they are exactly 8" or 203.2mm long.
Longest continuous joined PCB is 8. Remember if you are doing in and outs that the in and out PCBs will need to be reversed so best to do all ins and then all outs etc.
Example if there are 8 in and 8 outs. Use 2 x 8 way regurgitator PCB with one turned around.
If you want the in and outs to be next to each other look at the dingo pup kit instead.