For most modern mic splits nothing is needed at all except to leave off pin 1 on the second XLR outputs if hum loops are likely.aevan wrote:Hi Joe, ever thought of making a kit active mic splitter? Maybe the regurgitator could be the basis for it?
I don't know if there's a lot of call for one, or if people prefer passive splits, bit it seems the reason a lot of people use passives
is because of the cost involved to buy actives.
Just a thought, as I'm currently building a 16 way passive but would have loved a diy active alternative.
While active splits can be good in big live gig splits it is not recommended for recording as any active circuit running as low mic levels will add noise.