VCA

Support for JLM Audio Kits

Moderator: Joe Malone

Post Reply
User avatar
Joe Malone
Site Admin
Posts: 2069
Joined: Wed Jan 24, 2007 11:35 pm
Location: Brisbane, Australia
Contact:

VCA

Post by Joe Malone »

Below is a our small VCA PCB that has the same pinout and size as a 202 but can be built with inverting buffer opamp on board or not and also has up and down control voltage scaler on it so it can replace any 202 type. It also fits direct into auditronic consoles to upgrade there VCA PCB. Takes 1 to 4 x 218* VCA's and has parts so the VCA can run directly on +/-24v to +/-34v.

Image
Joe :-)
JLM Audio
Capturing Audio without Injury

syn
Posts: 6
Joined: Tue Mar 27, 2007 6:02 pm
Location: Belgrade-Serbia

Post by syn »

This is great. When will this board be available and at what cost?

cheerz

David Wilson
Posts: 1
Joined: Wed May 30, 2007 10:53 am

Post by David Wilson »

oH MAN.

If I can use this for my GYRAF SSL CLONE i will kiss you.

:lol: :lol: :lol: :lol: :lol: :lol:

Well maybe not but will be more than happy to hand over some hard earned cash.

Dam,n I want one now.

chrisp
Posts: 184
Joined: Sun Mar 04, 2007 11:46 am
Location: Sydney, Australia

Post by chrisp »

David

The GYRAF clone runs on +/- 15V, which is not enough juice for this board.

In any event, the GYRAF VCA chips are the same 7 pin SILs as those on this board, so you'd not gain very much (forgive the pun) compared to just stuffing the GYRAF PCB itself.

I've built a couple of the GYRAFs, and I know others on this forum who have done so as well - if you having any problems, perhaps we can help?
Chris P
---------------------------------------------------------
I do lots of things. I believe eclectic skills are best.

khstudio
Posts: 3
Joined: Sun Dec 30, 2007 1:11 pm
Location: New Jersey, USA
Contact:

Re: VCA

Post by khstudio »

Are these available yet?
If not, when?

thanks

Post Reply