Page 4 of 4

Re: Passive Controller Build Thread Ver 1 & 2

Posted: Sun Jul 05, 2020 9:30 pm
by Corpselectriques
Hi Joe

I see you add a note : Note 4. Do not push rotary switches down to the pcb as they may short on solder joints under them.

I cut the pins under the Switch short, but yes, I pushed them.

Do you think that's the cause !
It be too hard/long and not equipped to unsolder all the Switch pin for move it. I'm kind of stuck ! :x

Maybe for a next batch, it be a good think to move them side of the rotary switch for avoid problem.

best
F

Re: Passive Controller Build Thread Ver 1 & 2

Posted: Wed Jul 22, 2020 11:29 am
by dneilsen
Hi Joe
I have built the controller along with the tascam breakout pcb and I am not getting any sound out at all.

I suspect the issue lies in the ICB connections on the 26 wire ribbon cable and I am in the process of getting more connectors for this.

Can you please confirm that I have the dual 10k pot wired correctly?
20200722_112404.jpg
20200722_112344.jpg

Re: Passive Controller Build Thread Ver 1 & 2

Posted: Wed Jul 22, 2020 1:02 pm
by Joe Malone
dneilsen wrote:
Wed Jul 22, 2020 11:29 am
Hi Joe
I have built the controller along with the tascam breakout pcb and I am not getting any sound out at all.

I suspect the issue lies in the ICB connections on the 26 wire ribbon cable and I am in the process of getting more connectors for this.

Can you please confirm that I have the dual 10k pot wired correctly?

20200722_112404.jpg

20200722_112344.jpg
You need to add a link from the centre pin to the right pin on the front and back pot so the volume will work. At the moment the volume should be stuck on full.