Micro Passive Mixer Build Thread

Support for JLM Audio Kits

Moderator: Joe Malone

User avatar
Joe Malone
Site Admin
Posts: 1548
Joined: Wed Jan 24, 2007 11:35 pm
Location: Brisbane, Australia
Contact:

Micro Passive Mixer Build Thread

Postby Joe Malone » Wed Mar 02, 2016 4:58 pm

Blank Micro Passive Mixer PCB
Image

Fit 4 x resistor SIL packs so dot on side marking pin 1 goes to square solder pad. Fit them hard down to the PCB and solder & trim legs.
Image

Fit 3 x Zero link resistors or 2 wire links between the SIL resistors. Fit them hard down to the PCB and solder & trim legs.
Image

Slide PCB fully into D25 connector betwen the 2 rows of terminals. Solder one terminal at each end and then solder all top and bottom terminals to the PCB.
Image
Image

IN and OUR XLRs are wired in parallel so can be split either at the PCB or in the XLR connector.
Note: If only making a 8 to 2 mixer the IN cables and XLRs can be left off. XLR wiring RED to pin 2, White to pin 3, Sheild to pin 1
Image
Joe :-)
JLM Audio
Capturing Audio without Injury

Return to “JLM Audio Kits”

Who is online

Users browsing this forum: Google [Bot] and 3 guests