struggling with Go between and Fet DI

Support for JLM Audio Kits

Moderator: Joe Malone

Post Reply
permeke
Posts: 19
Joined: Sat Apr 09, 2011 10:35 pm

struggling with Go between and Fet DI

Post by permeke »

I can't get my head around this:

Go between with Fet DI.

Gobetween works as it should be with microphone input and with the two bridge adaptors on the 10 pin connector.
Gobetween and Fet DI connected with the flat cable: DI input works , Mic input doesn't.

Did I connected the flat cable the wrong way and damaged the relais ?

User avatar
Joe Malone
Site Admin
Posts: 2069
Joined: Wed Jan 24, 2007 11:35 pm
Location: Brisbane, Australia
Contact:

Re: struggling with Go between and Fet DI

Post by Joe Malone »

permeke wrote:I can't get my head around this:

Go between with Fet DI.

Gobetween works as it should be with microphone input and with the two bridge adaptors on the 10 pin connector.
Gobetween and Fet DI connected with the flat cable: DI input works , Mic input doesn't.

Did I connected the flat cable the wrong way and damaged the relais ?
Send a photo of the ribbon cable and top and bottom of the FetDI pcb to my email so I can check it over.

Red stripe should line up with the triangle on each 10 pin plug and socket. If made with one end reversed it shorts out the 48v power rail protecting the FetDI and GO between kit.

Can you hear the relay click when you plug in and out of the DI socket?

What 48v power supply are you using? Is it still 48v when nothing is plugged into the DI socket?
Joe :-)
JLM Audio
Capturing Audio without Injury

Post Reply