Warbler wrote:You are so helpful! I really appreciate that.
Build looks good. Start with the below and answer the questions and we should be able to get you going ASAP.
OK check the 10pin plug going into the GO between input as it doesn't look fully plugged in. Sitting out a few mm.
Do you have an extender cable? Y/N
First check you have all 3 power rails +/-16v and 48v at the back edge connector of the BA500? Y/N.
(Pin 13 is 0v for black meter probe, Pin 15 = 48v, Pin 14 = -16v, Pin 12 = +16v.
When you plug a jack into the DI input slowly can you hear the white relay click on and off? Y/N
With nothing plugged into the BA500 input turn up your monitors and see if the output hiss level goes up when you turn up the BA500 gain pot? Y/N
Did you get a dummy plug in your kit (10 pin header with hot melt glue on the back)? Y/N