JLM AUDIO

Posted: **Fri Mar 04, 2011 10:26 pm**

Hi,
I'm putting a variable pad kit on a go between with no di. Can I just strap the two pairs of connect points on the pad board where the di socket goes with some wire and leave out the di socket?
I haven't got any IDC jumpers handy.
Thanks.

Andy

Posted: **Fri Mar 04, 2011 10:51 pm**

aevan wrote:Hi,
I'm putting a variable pad kit on a go between with no di. Can I just strap the two pairs of connect points on the pad board where the di socket goes with some wire and leave out the di socket?
I haven't got any IDC jumpers handy.
Thanks.

Andy

Yes the 2 jumpers from the Go between kit are used in the DI socket on the Variable PAD if no DI is fitted. But yes you can just leave out the 10pin header and wire the 2 points together.

Posted: **Fri Mar 04, 2011 10:51 pm**

My mistake, I didn't see the jumpers in the bag, but just went and looked and they are there.
Thanks Joe.

JLM AUDIO

Go Between / Variable pad noob question - strapping

Go Between / Variable pad noob question - strapping

Re: Go Between / Variable pad noob question - strapping

Re: Go Between / Variable pad noob question - strapping