Hi,
I'm putting a variable pad kit on a go between with no di. Can I just strap the two pairs of connect points on the pad board where the di socket goes with some wire and leave out the di socket?
I haven't got any IDC jumpers handy.
Thanks.
Andy
Go Between / Variable pad noob question - strapping
Moderator: Joe Malone
- Joe Malone
- Site Admin
- Posts: 2081
- Joined: Wed Jan 24, 2007 11:35 pm
- Location: Brisbane, Australia
- Contact:
Re: Go Between / Variable pad noob question - strapping
Yes the 2 jumpers from the Go between kit are used in the DI socket on the Variable PAD if no DI is fitted. But yes you can just leave out the 10pin header and wire the 2 points together.aevan wrote:Hi,
I'm putting a variable pad kit on a go between with no di. Can I just strap the two pairs of connect points on the pad board where the di socket goes with some wire and leave out the di socket?
I haven't got any IDC jumpers handy.
Thanks.
Andy
Joe
JLM Audio
Capturing Audio without Injury
JLM Audio
Capturing Audio without Injury
Re: Go Between / Variable pad noob question - strapping
My mistake, I didn't see the jumpers in the bag, but just went and looked and they are there.
Thanks Joe.
Thanks Joe.