Go Between / Variable pad noob question - strapping

Support for JLM Audio Kits

Moderator: Joe Malone

Post Reply
aevan
Posts: 9
Joined: Fri Mar 04, 2011 9:26 pm

Go Between / Variable pad noob question - strapping

Post by aevan »

Hi,
I'm putting a variable pad kit on a go between with no di. Can I just strap the two pairs of connect points on the pad board where the di socket goes with some wire and leave out the di socket?
I haven't got any IDC jumpers handy.
Thanks.

Andy

User avatar
Joe Malone
Site Admin
Posts: 2070
Joined: Wed Jan 24, 2007 11:35 pm
Location: Brisbane, Australia
Contact:

Re: Go Between / Variable pad noob question - strapping

Post by Joe Malone »

aevan wrote:Hi,
I'm putting a variable pad kit on a go between with no di. Can I just strap the two pairs of connect points on the pad board where the di socket goes with some wire and leave out the di socket?
I haven't got any IDC jumpers handy.
Thanks.

Andy
Yes the 2 jumpers from the Go between kit are used in the DI socket on the Variable PAD if no DI is fitted. But yes you can just leave out the 10pin header and wire the 2 points together.
Joe :-)
JLM Audio
Capturing Audio without Injury

aevan
Posts: 9
Joined: Fri Mar 04, 2011 9:26 pm

Re: Go Between / Variable pad noob question - strapping

Post by aevan »

My mistake, I didn't see the jumpers in the bag, but just went and looked and they are there.
Thanks Joe.

Post Reply