Go between troubleshooting - phantom
Posted: Sat Jul 17, 2010 12:58 am
Hi guys,
I have a Go between that's popping when 48v is enabled/disabled; the phase/pad pop when the 48v is activated too. The popping seems to gradually decrease after time at the pad/phase when repeatedly switched. Is this a short? Bad cap?
Also, on the channels that do work ok...i have 48v at the mic input, but i also have 48v at the input transformer primary?
Is this normal?
Thanks
I have a Go between that's popping when 48v is enabled/disabled; the phase/pad pop when the 48v is activated too. The popping seems to gradually decrease after time at the pad/phase when repeatedly switched. Is this a short? Bad cap?
Also, on the channels that do work ok...i have 48v at the mic input, but i also have 48v at the input transformer primary?
Is this normal?
Thanks