Search found 6 matches
- Fri Aug 31, 2012 6:07 pm
- Forum: JLM Audio Kits
- Topic: Go Between Humm
- Replies: 2
- Views: 10534
Re: Go Between Humm
Thanks for the answer. I checked xlr pin: all is ok except Pin 1 at the preamp xlr out connected to ground. I removed it. So i tested again with condenser mic: always big noise. I changed mic: no noise....!!!!! I think i made a big mistake few days ago that break my condenser mic....sniff. I will op...
- Wed Aug 29, 2012 5:48 am
- Forum: JLM Audio Kits
- Topic: Go Between Humm
- Replies: 2
- Views: 10534
Go Between Humm
Hi, i plug a Go between card on my 1290EZ préamp: between the input transformer and the input XLR plug. All is ok with Pad and phase reverse switch. Préamp works properly. But when i switch on phatom power: I ve got humm: 350hz, 715hz and 1000hz. Condenser mic works but there's some humm. So i check...
- Fri Jun 17, 2011 7:44 pm
- Forum: JLM Audio Kits
- Topic: MAC RACK KIT with Green MAC & DINGO PCBs Build Thread
- Replies: 62
- Views: 205574
Re: MAC Build Thread
Hi, I have a look on the shop, and i seen 2 different Dingo kit. Wich one do i need ?
And when i see your picture, there's a lot of missing components on pcb......
it seems to be difficult for me....
And when i see your picture, there's a lot of missing components on pcb......
it seems to be difficult for me....
- Fri Jun 17, 2011 12:04 am
- Forum: JLM Audio Kits
- Topic: MAC RACK KIT with Green MAC & DINGO PCBs Build Thread
- Replies: 62
- Views: 205574
Re: MAC Build Thread
Ok Joe, thanks a lot for your response and your job. I think i will buy a Dingo kit in few weeks......
- Wed Jun 15, 2011 6:07 pm
- Forum: JLM Audio Kits
- Topic: MAC RACK KIT with Green MAC & DINGO PCBs Build Thread
- Replies: 62
- Views: 205574
Re: MAC Build Thread
Hi,
I just bought 1 MAC comp kit, i want to plug it inside my neve preamp. I just see that There a dingo kit, so my question is: can i use Mac comp without Dingo pcb?
If yes, how to plug +V and Signal in/out
thanks a lot.....
I just bought 1 MAC comp kit, i want to plug it inside my neve preamp. I just see that There a dingo kit, so my question is: can i use Mac comp without Dingo pcb?
If yes, how to plug +V and Signal in/out
thanks a lot.....
- Thu Aug 05, 2010 9:21 pm
- Forum: JLM Audio Kits
- Topic: AC/DC & POWERSTATION KIT BUILD THREAD
- Replies: 350
- Views: 843170
Re: AC/DC & POWERSTATION KIT BUILD THREAD
hello, I have few questions about ACDC kit, I would like +24V-2A, 0V, and 48V. Is it possible to change something in order to have 2A? I dont need -V, what i have to write in calculator, in -v box? 0V,0A? If I need +24V, do i need 25V or 22V transformer? Excuse-me for my language, i'm french...... A...