Search found 6 matches

by nikonet
Fri Aug 31, 2012 6:07 pm
Forum: JLM Audio Kits
Topic: Go Between Humm
Replies: 2
Views: 3891

Re: Go Between Humm

Thanks for the answer. I checked xlr pin: all is ok except Pin 1 at the preamp xlr out connected to ground. I removed it. So i tested again with condenser mic: always big noise. I changed mic: no noise....!!!!! I think i made a big mistake few days ago that break my condenser mic....sniff. I will op...
by nikonet
Wed Aug 29, 2012 5:48 am
Forum: JLM Audio Kits
Topic: Go Between Humm
Replies: 2
Views: 3891

Go Between Humm

Hi, i plug a Go between card on my 1290EZ préamp: between the input transformer and the input XLR plug. All is ok with Pad and phase reverse switch. Préamp works properly. But when i switch on phatom power: I ve got humm: 350hz, 715hz and 1000hz. Condenser mic works but there's some humm. So i check...
by nikonet
Fri Jun 17, 2011 7:44 pm
Forum: JLM Audio Kits
Topic: MAC RACK KIT with Green MAC & DINGO PCBs Build Thread
Replies: 62
Views: 91829

Re: MAC Build Thread

Hi, I have a look on the shop, and i seen 2 different Dingo kit. Wich one do i need ?
And when i see your picture, there's a lot of missing components on pcb......

it seems to be difficult for me....
by nikonet
Fri Jun 17, 2011 12:04 am
Forum: JLM Audio Kits
Topic: MAC RACK KIT with Green MAC & DINGO PCBs Build Thread
Replies: 62
Views: 91829

Re: MAC Build Thread

Ok Joe, thanks a lot for your response and your job. I think i will buy a Dingo kit in few weeks......
by nikonet
Wed Jun 15, 2011 6:07 pm
Forum: JLM Audio Kits
Topic: MAC RACK KIT with Green MAC & DINGO PCBs Build Thread
Replies: 62
Views: 91829

Re: MAC Build Thread

Hi,

I just bought 1 MAC comp kit, i want to plug it inside my neve preamp. I just see that There a dingo kit, so my question is: can i use Mac comp without Dingo pcb?
If yes, how to plug +V and Signal in/out

thanks a lot.....
by nikonet
Thu Aug 05, 2010 9:21 pm
Forum: JLM Audio Kits
Topic: AC/DC & POWERSTATION KIT BUILD THREAD
Replies: 319
Views: 273594

Re: AC/DC & POWERSTATION KIT BUILD THREAD

hello, I have few questions about ACDC kit, I would like +24V-2A, 0V, and 48V. Is it possible to change something in order to have 2A? I dont need -V, what i have to write in calculator, in -v box? 0V,0A? If I need +24V, do i need 25V or 22V transformer? Excuse-me for my language, i'm french...... A...

Go to advanced search