JLM AUDIO

awguitars wrote:would love to do this kit.

any ideas if its going to be released?

I would still really love to do this kit.

are you holding off because of your commercially available versions?

Hi joe.

I was thinking the exact same thing. Only i was thinking of building a dual BA/MAC into a single rack unit.

My main question is how to power the unit.
I was considering buying a larger SMPS and building it into the unit. If this works how do i setup the power supplies to the 4 units?

would love to do this kit.

any ideas if its going to be released?

I've built and tested my power station. 48v reads fine but the other rails wont go above 21v or so and they are not at the end of the trim pot windings (the clicking occurs some time after) i have used a 20VA 15-0-15 Volt transformer. is this insufficient? I am using the trippler and i have the tran...

Firstly, wow amazing, you replied on Sunday at 10pm. within 5 minutes of my question. ok, fault finding time. I have looked over the board and am trying to figure out what is wrong. I put the zener's in and removed those components. Usually best not to remove parts that make no difference as it can...

Correct me if i am wrong. I'm just starting to learn all this stuff. But when using output transformers and Discrete op amps is there need to put R17, R18, R20, C13, And C11 on the dingo PCB? Yes those parts can be left off in that setup. Also i noticed the previous versions of the dingo did not ha...

Correct me if i am wrong. I'm just starting to learn all this stuff. But when using output transformers and Discrete op amps is there need to put R17, R18, R20, C13, And C11 on the dingo PCB? Also i noticed the previous versions of the dingo did not have zener diodes next to IC 1 do i need to put th...