JLM AUDIO

sorry extra photos didn't attach.

Here's U2 opto cell:
Here's phanotm cap C5 (47uf instead of 22uf):
cheers

hello again - had some time recently to continue working on this. Haven't been able to get it to work - so far it seems the power isn't turning on properly. I did the following modifications: 1. link P2 pin7 to E2 pin 6 2. link E2 pin1 to E2 pin4 3. remove E2 pin 2 Here's a photo. Pin is removed fro...

ripper - yes i'll confirm how she goes

great, just emailed you the schematic for eq module!

ok great to know yeah before attempting to rack this VR channel, i never understood how many varieties of neve circuits were made. do you have pin outs / schematic for a V-series EQ card with two ribbon cable connectors? I'm going to attempt to patch it. Or even a 51-series EQ such as EV10880, altho...

Update: There's at least 3 different neve V series: V2,V3,VR Based on my research, the EQ module I have is from a VR channel, and these EQ modules have 3 ribbon cable connectors, not 2. V2 channel uses 2 ribbon cables V3 channel uses 3 ribbon cables VR channel uses 3 ribbon cables Are Neve VR series...

hey i am racking up a neve V channel have assembled the power supply, switched it on, checked voltages etc are g. now i am going to start plugging the EQ / preamp / comp modules into the board. however, my problem is that i cannot figure out how to attach the EQ module. the JLM interconnector has TW...

Hey Joe, just have a question about my BA's...I'm using the 48v 40w SMPS with four BA's in the same rackmount case, and am getting a strange noise problem. The SMPS is located outside the unit. I have no noise floor problems when no sound is being played into a microphone and to my ears all the pre'...