Stuffing sheet for Dual JLM99v Mic Pre Kit

If Rx or Cx part is not listed below it is not fitted and left blank. 

R1 = 6k8
R2 = 6k8
R4 = 470R
R5 = 470R
R6 = 100R
R7 = 470R
R8 = 33R
R9 = Resistor for Zobel load if transformer needs one. JLM1:4, LL1538, LL1578, A262A3E do not need one fitted.
R10 = Load for input transformer 10k for JLM1:4, 5k6 to 47k for LL1538, 47k for LL1578, 27k for A262A3E OEP. 
R11 = 0R (Cream resistor with one black band)
R15 = 1k8(60dB) 1k5(65dB) 1k(70dB) (overall gain depends on the ratio of input and output transformer used)
R16 = 22k
R18 = 300R 
R22 = 1k8(60dB) 1k5(65dB) 1k(70dB) (overall gain depends on the ratio of input and output transformer used)
R23 = 22k
R24 = 51R
R25 = 51R
R26 = 100k
R27 = 100k
R28 = 10R
R29 = 10R
R30 = 100R
R31 = 300R on switch PCB
R32 = 300R on switch PCB
R33 = 300R on switch PCB

C1 = 10uF 63v electro
C2 = 0.1uF Mono Cap
C3 = Capacitor for Zobel load if transformer needs one. JLM1:4, LL1538, LL1578, A262A3E do not need one fitted. 
C4 = 10uF 35v to 63v electro
C9 = 100uF 50v Bipolar (can go in either way)
C10 = 47pF Ceramic
C11 = 0.1uF Mono Cap
C12 = 0.1uF Mono Cap
C19 = 100uF 50v Bipolar (can go in either way)
C20 = 47pF Ceramic
C21 = 0.1uF Mono Cap 
C22 = 0.1uF Mono Cap
C23 = 1000uF 10v to 35v electro
C24 = 1000uF 10v to 35v
C25 = 100uF 35v to 63v
C26 = 100uF 35v to 63v
C27 = 100uF 50v to 63v
C28 = 0.1uF Mono Cap on switch PCB
C29 = 0.1uF Mono Cap on switch PCB
C30 = 0.1uF Mono Cap on switch PCB (wrongly marked as a second C28 on PCB)

Reg1 = LM317
Reg2 = Not fitted. JUmper strap as shown on overlay fitted instead.
Reg3 = Not fitted. JUmper strap as shown on overlay fitted instead.

Sw1 or Relay 1 = Either PCB DPDT Switch Fitted or 5v micro 10pin relay fitted as shown on overlay
Sw2 or Relay 2 = Either PCB DPDT Switch Fitted or 5v micro 10pin relay fitted as shown on overlay
Sw3 or Relay 3 = Either PCB DPDT Switch Fitted or 5v micro 10pin relay fitted as shown on overlay